HOME >  Flex Circuit Inspection Tools INDEX  > Dust Remover Sheet DRS Series

same day

Dust Remover Sheet

DRS Series

DRS-05/-10/-150

Sheets with a thickness of 0.3 mm are available in three types of sheet width specifications.
(5mm wide/10mm wide/15mm wide)
This products can be used to clean the probe simply by inserting the sheet into the flexible wiring connection slot. Simply working the clip several times cleans the probe, so there is no need to disassemble the connector clip.

Using with clip connectors

Using with flexible wiring clip connectors

We will sequentially switched to the product of non-conductive. The color of the non-conductive is yellow.

Using with flexible wiring clip connectors

Work the clip gently several times with the sheet
inserted into the flexible wiring connection slot.

DRS-A4

Because the sheet is only 1.5 mm thick, it can be inserted deeply into the probe. It is well suited for long probes attached to frame jigs and pin boards and the like. Because the adhesive is present on both sides of the sheet, the sheet resists sliding when it is simply placed on the board. You can also reverse the sheet once one side becomes soiled.

Using with a probe installed on
a frame jig or pin board

Example of use with a frame jig

We will sequentially switched to the product of non-conductive. The color of the non-conductive is yellow.

use sample

※Use only after removing the protective sheet.

At the request of many users, we are taken by the sequentially switched to the product corresponding to the non-conductive. The product of conductivity, green, non-conductive, is yellow.

Product Overview

You can remove dust simply by pressing the probe tip against this sheet

■This sheet uses the adhesion of the material itself to remove dust from the tip of the probe.
■This product differs from adhesive tape because no adhesive material remains on the probe. You can use it with complete confidence.
■Available in two sheet thicknesses: 0.3 mm and 1.5 mm.

■This sheet is not intended to remove dirt that has become embedded over time. Please use this sheet for relatively light cleaning by contacting the probe several times
(every 500 to 1,000 cycles).
■Use only at room temperature.
■Cut off and discard any dirty parts after use. We recommend cutting off areas that have been used about 60 times. Each sheet can normally be cut about seven times when used with clip connectors.
(The 1.5-mm-thick Dust Remover Sheets can be reused multiple times if washed occasionally with neutral detergent or water.)

Cleaning Test

Probes with quartered tips

Probes with quartered tips

Probes with pointed tips

Probes with pointed tips

price list

Product No. Product Specifications Units per
package
Price (set of 10 in US $)
1set 2~4 sets 5~9 sets 10 sets or more
DRS-05 0.3mm thick 5mm wide 60 per set 134 128 123 117
DRS-10 0.3mm thick 10mm wide 60 per set 167 162 156 150
DRS-150 0.3mm thick 150mm wide 4 per set 123 117 112 106
DRS-A4 1.5mm thick A4-size 1 sheet 167 162 156 150

lineup

  • 0.2mm
    • CCJF-020M series
  • 0.25mm
    • CCJF-025M series
  • 0.3mm
  • 0.4mm
  • 0.5mm
  • 0.8mm
  • 1.0mm
  • 1.25mm
    • CCS-125 series
  • CCPO series
    • CCPO series
  • PFC series
  • repair parts
  • maintenance
  • Actuator Opener
  • HIROSE FH-58 Flex Insertion Tool

top of page